Dell OptiPlex 320 User Manual page 137

Hard-disk drive failure —
Hard-disk drive failure —
See Drive Problems.
Insert bootable media — Insert a bootable floppy disk or CD.
Invalid configuration information - please run SETUP program —
(see System Setup).
Keyboard failure — See Keyboard
Memory address line failure at address, read value expecting value —
Memory allocation error —
1. Turn off the computer, wait 30 seconds, and then restart the computer.
2. Try to run the program again.
3. If the error message appears again, see the software documentation for additional troubleshooting suggestions.
Memory data line failure at address, read value expecting value —
Memory double word logic failure at address, read value expecting value —
Memory odd/even logic failure at address, read value expecting value —
Memory write/read failure at address, read value expecting value —
Memory size in CMOS invalid —
See Lockups and Software Problems.
No boot device available —
If the floppy drive is your boot device, ensure that a bootable floppy disk is in the drive.
l
If the hard drive is your boot device, ensure that the cables are connected and that the drive is installed properly and partitioned as a
l
boot device.
Enter system setup and ensure that the boot sequence information is correct (see
l
No boot sector on hard-disk drive —
Enter system setup and ensure that the computer configuration information for the hard drive is correct (see
l
No timer tick interrupt — Run the Dell Diagnostics. See
Non-system disk or disk error —
drive A and restart the computer.
Not a boot diskette — Insert a bootable floppy disk and restart your computer.
Not enough memory or resources. Close some programs and try again —
In some cases, you might have to restart your computer to restore computer resources. If so, run the program that you want to use first.
Operating system not found —
Problems.
Dell Diagnostics.
Replace the floppy disk with one that has a bootable operating system or remove the floppy disk from
Enter system setup and correct the computer configuration information
See Lockups and Software Problems.
System Setup).
Close all windows and open the program that you want to use.
System Setup).