Assembly Instructions - Health O Meter 2842KL Operation Manual

ASSEMBLY INSTRUCTIONS

This 2842KL scale has been calibrated at the factory. It is shipped in four assembled parts:
the base assembly, the display assembly, the rubber mat and rubber feet. Remove each
assembly from its carton and unwrap packing material carefully to prevent scratching the
unit's parts.
1. Place the base assembly upside down on a steady surface.
2. Screw the four feet onto the base assembly as shown.
3. Turn the base assembly right side up.
4. Plug the display cable connector into the base cable connector.
5. Place the display assembly on the table or mount it on the wall, as desired.
For mounting the display assembly on the wall use 5/16" or 8mm drill bit.
6. Place the rubber mat on the base assembly, inside the designated frame.
The scale may be operated by an AC power source adapter or by 6-C cell batteries.
The scale will automatically switch to battery operation when an AC power source is absent.
Figure 1. Assembly After Shipment
3