Operating The Camera; Product Description - Glonex GLOCAM GC1 User Manual

9

Operating the Camera

Title Operation
T
Power connection
Power On
to the device
The angle of the Adjust camera up
front camera and down
Event Recording Shock detection
Press Manual Record
Manual Record
Button
Select the Internal Press LED
Voice Recording
Button (ON/OFF)
Press and hold LED
Rear Camera
Button (ON/OFF)
Control (GC2)
Press and hold the Manual
Select the Parking
Recording Button
Mode
(ON/OFF)
Disconnect the power cable
Power OFF
or turn off engine
No insertion
of SD card
Card Errors
1. Save the new firmware to root of micro SD™ Card
2. Insert the SD™Card into the slot.
3. Connect the Power Cord. This will start the update
mode and voice message will state
"Start Program Updating".
4. LED will flash Red-Blue-Purple during update.
Firmware Update
5. When update is complete, voice message will state
"Update Completed". The LED will flash purple, and
the unit will beep. When this occurs, disconnect the
power.
Function Voice Message
Beeps after
Recording start
"Welcome"
The front camera
angle adjustment
Event Record Storage
"Event"
Saves Manual Recording "Manual Recording"
Voice recording (Default)
"Audio locked"
ON-flashing red LED
"Audio unlocked"
OFF-flashing blue LED
Rear Camera
Rear Camera "On"
ON / OFF
Rear Camera "Off"
Parking Mode ON/OFF
"Parking mode On"
Flashing LED long
"Parking mode Off"
Recording with 10fps
Camera will turn off when
the reserve power is
depleted. (About 5 Min.)
"Insert SD™ Card"
"Check SD™ Card"
"Start Program Updating"
"Update Completed"

Product Description

Recording
After inserting the micro SD™ Card, power up the camera by attaching
the power cord and plugging it into a 12-V receptacle (Cigarette Lighter).
LED will flash purple.
Voice message "Welcome" will be heard.
LED will flash red at 1 second intervals.
Unit will beep when camera is ready to record.
When an event is detected by the G-Sensor, the LED light will flash blue and red.
If there is a substantial bump, dip, swerve or stop the voice message will state
"Event".
Power Off - LED will cease flashing. When LED light is off, it is safe to remove the
micro SD™ Card without damaging it or the camera.
Parking Mode - LED will flash every 4 seconds. Recording is being saved on the
micro SD™ Card at 10fps.
To save any important recorded data, remove card, copy and save to your
computer.
10