Glonex GLOCAM GC1 User Manual page 3

3
Warning
Do not disassemble the camera. This will void the warranty and
possibly cause failure, electric shock or fire. Please contact Glonex,
Inc. for repair issues.
Do not operate while driving.
Make sure to place it where it will not block the driver's line of vision
when installing the camera.
Do not move or adjust the camera while driving.
You should have the camera installed by a professional if using the
Harness Power Cable for direct power from the battery.
When installing the camera, be careful not to cut or damage the
power cord.
Caution
1.
Do not pull out the micro SD™ Card when the camera has the power supply
attached. This may damage the card.
2.
Do not use the micro SD™ Card in any other device othrer than a smartphone.
3.
Make sure that your hands are clean and dry before handling the SD™ Card;
do not touch the metal end. Water and dirt can cause contamination of the
card, which may damage it.
4.
Do not insert any other objects other than the micro SD™ Card into the card
slot. This may damage the card slot.
5.
Make sure that the adapter is plugged in securely to the 12-V supply.
Secure contact is necessary for data recording.
6.
Wipe the camera with a soft, dry cloth when cleaning. Do not use water
or chemicals to clean.
7.
Avoid dropping the camera and otherwise subjecting it to severe impact.
This may damage the camera.
8.
Using a defective memory card may cause data loss; it is recommended
that you use a Micro SD™ Card only.
9.
Camera requires a few seconds to activate; unit will beep when recording
has started.
10.
Some vehicles have a metal coating on the windshield. Installing on this
can cause a weak GPS Signal and obscure the lens view.
11.
The contents of these instructions are subject to change without notice.
4