Limiting The Pan & Tilt Range; Included Mounts - Security Labs SLC-170C Owner's Manual

7. Manually Limiting the Pan & Tilt Range
The maximum angle of the pan/tilt mechanism is set at the factory (horizontal: maximum
356º, vertical: maximum 90º), it is unnecessary to adjust the limits of the mechanism
unless there are special requirements of the installation.
You can limit the pan range of your camera by adjusting the stop tabs (slices) on top of the
mechanism. Please remove the mechanism from the top section of the housing by
loosening its four Philips head mounting screws, loosen the horizontal locknut of the
bracket, and adjust the protruding position of two limit slices (tabs) to get the limited pan
range you desire.
Again, this adjustment is not needed unless there is an area you wish the camera operator not
to view (i.e. windows behind the camera versus the parking lot in front of it).
8. Mounts included with your kit
Ceiling Mount Wall Mount
6