Bond GSF2616AC Owner's Manual page 9

Step 4
a) Insert the axle (Y) into the holes on the right front leg
and back leg.
b) Put one collar (JJ) on each end of the axle, and then
put one wheel (X) on each end of the axle. Screw
one lock nut (II) on each end of the axle using the
wrench (LL) provided.
c) Insert one wheel cap (W) on each wheel.
GSF2616AC
Owner's Manual
Step 3
a) Loosen the two pre-installed bolts on the left back leg and the left front
leg, and allow 1/4 bolt's length to extend from the legs. Align the holes
on the upper side beam (S) with the extended two bolts on the legs.
Push down on the upper side beam until it clocks into place, insert one
bolt (AA), one spring washer (CC) and one flat washer (DD) into each
hole on the legs. Tighten by hand until secure.
b) Repeat the procedure for the right upper side beam assembly (U).
c) Loosen the lower two pre-installed bolts on the left front leg and back
leg, and allow 1/4 bolt's length to extend from the legs. Align the holes
on the side panel (T) with the extended two bolts on the legs. Push
down on the side panel until it locks into place. Tighten by hand until
secure. Repeat the procedure for the right side panel assembly (V).
d) Go back and tighten all the bolts using the screwdriver provided.
Step 5
a) Hook one end of the tank clip (Z) with the cart right side
panel beam, Insert one bolt (AA), one spring washer (CC)
and one flat washer (DD) into the hole on the other end of
the tank clip (Z) and the hole on the left side panel beam.
Tighten by hand until secure.
b) Hook one end of the tank clip (AC) with the cart left upper
panel beam, Insert one bolt (AA), one spring washer (CC)
and one flat washer (DD) into the hole on the other end of
the tank clip (AC) and the hole on the left side panel beam.
Tighten by hand until secure.
c) Insert one bolt (AA), one spring washer (CC) and one flat
washer (DD) into the hole on the end of the tank clip (AB)
and the hole on the right back leg. Repeat the procedure on
the left back leg. Tighten by hand until secure.
d) Go back and tighten the bolt using the screwdriver provided.
8