Bond GSF2616AC Owner's Manual page 10

Step 6
a) Place the body assembly (A) on the cart assembly.
b) Align the holes on front legs with the holes on the body
assembly(A), then insert one bolt (AA), one spring washer (CC)
and one flat washer (DD) into each hole. T
secure.
c) Align the hole on each back leg with the holes on body
assembly. Insert one bolt (AA), one spring washer (CC) and
one flat washer (DD) into each hole. T
secure.
d) Go back and tighten all bolts using the screwdriver provided.
Step 8
a) Align the two holes on right side of body assembly with the
two holes on the right side shelf. Then insert one bolt (BB),
one spring washer (CC) and one flat washer (DD) into each
hole. T ighten by hand until secure.
b) Repeat the procedure for the left side of the body assembly.
c) Go back tighten all bolts using the screwdriver provided.
GSF2616AC
Owner's Manual
ighten by hand until
ighten by hand until
9
Step 7
a) Loosen the four pre-installed bolts on the side of control
panel and left back leg, and allow 1/4 bolt's length to
extend, align the holes on the left side shelf (G) with the
extended bolts, then push down on the left side shelf
until it clocks into place, tighten by hand until secure.
b) Repeat the procedure for the right side shelf (H)
assembly.
c) Go back and tighten all the bolts using the screwdriver
provided.