Husqvarna LE389 Operator's Manual page 28

How To Change The Oil
Change oil after first 5 to 8 hours of use, then
every 50 hours. Change oil every 25 hours when
operating the engine under heavy load or in high
temperatures.
1 Disconnect the spark plug wire and keep it away
from the spark plug.
2 Clean the area around the oil fill cap (A) and the oil
drain plug (B) of dirt and debris. See Figure 27.
3 With engine off but still warm, remove the oil drain
plug (B). Completely drain all of the oil from the
engine into an appropriate receptacle.
4 After draining all the oil, install and tighten the oil
drain plug.
5 Make sure the engine is level.
6 Remove the oil fill cap (A) from the engine oil fill
(C).
7 To add oil, pour the oil slowly into the engine oil fill.
The engine holds approximately 20 ounces (0.6
liter) of oil. For the type of oil to use, see "Oil
Recommendation" in the Operation Section.
8 Connect the spark plug wire to the spark plug.
26
C
A
C
Figure 27: Change Oil
B
www.usa.husqvarna.com