Electrical Connection - Brilix XHP 40 Installation And User Manual

5. Electrical connection

5.1 Connection diagram for the swimming pool heat pump
XHP 40, XHP 60, XHP 100
IMPORTANT: The installation and connection of this device to the power supply can only be provided by
a person that has the electrical qualifications in accordance with Decree No. 50/1978 Coll. Although the heat
pump is electrically insulated from the rest of the unit, this fact only prevents the passage of electrical current
to or from the water in the swimming pool. It is still necessary to earth the unit, to prepend the circuit breaker
with the current value according to the type of heat pump and current protector with residual current 0.03 A.
Before connecting the heat pump, check whether the electrical mains voltage corresponds to the operating
voltage of the heat pump.
white
Compressor red
blue
POWER SUPPLY SINGLE WATER
220−240 V/50 Hz PUMP
*Section marked with dotted lines is only in some models.
white
Fan motor
brown
OUTPUT1 OUTPUT2
brown
red
red
blue
OUTPUT3
black
OUTPUT4
Transformer
OUTPUT5
yellow
blue
blue
brown
yellow/green
RUN/ POWER SUPPLY
Cooling coil temperature sensor
GROUND
GROUND Ambient temperature sensor
Returned coolant temperature sensor
GROUND
Heating coil temperature sensor
GROUND
Water outlet coil temperature sensor
GROUND
Water inlet coil temperature sensor
GROUND
9
EN