Brilix XHP 40 Installation And User Manual page 7

ATTENTION:
Please follow the steps below to put the heat pump into operation for the first time:
1. Open the valves to let water into the system.
2. Make sure there is no water leaking in the connections.
3. Run the heat pump with the circulating pump in operation.
4.2 Selection of the installation position
• It is recommended to install the heat pump in a sunny, spacious and well ventilated place.
• Its position has to guarantee the smooth circulation of air (the location of the air inlet is shown in the
diagram below).
• When operated, the heat pump can produce a substantial amount of water condensate and therefore it is
necessary to take its occurrence into account.
• The installation base has to be firm enough to ensure smooth operation of the device.
• Make sure the device, when installed, is situated vertically, without any inclination.
• Do not install the device in places where there is contamination, corrosive gas or where dirt or fallen leaves
accumulate.
• The heat pump must not be installed in the vicinity of an environment with an inflammable or explosive
atmosphere with common fire hazards.
• Maintain the distances from obstacles as indicated with arrows in the next figure.
7
EN