Replacing Headlight Lamp (H4); Cooling System - KTM 125SX Owner's Handbook Manual

Hide thumbs Also See for 125SX:
Table of Contents

Advertisement

1
5
26
7

Replacing headlight lamp (H4)

Loosen both rubber bands
bulb plug
2
clockwise and remove it from the reflector together with the bulb.
3
Insert a new bulb such that the noses
the glass body of the bulb, to keep if free from grease. Mount supporting
ring, rubber cap and plug. Position headlight mask with the bottom holders,
and fasten it with the rubber bands.
4

Cooling system

The water pump in the engine circulates the cooling liquid. However, the
cooling liquid can only circulate properly if the cooling circuit contains no air
bubbles.
Bleeding of the cooling system is therefore required
a) after adding more than 0.25 l cooling liquid and
b) after refilling the entire cooling system.
(see Bleeding the cooling system).
6
Some models are equipped with a thermostat
its operating temperature more quickly. When the engine is cold, the liquid
coolant circulates in the cylinder and the cylinder head. As soon as the coo-
ling liquid has reached a temperature of approximately 55°C, the ther-
mostat opens and the cooling liquid is also pumped through the two alumi-
num radiators.
The cooling liquid is cooled by the air stream. This means that the cooling
effect decreases with the travelling speed. Dirty radiators additionally
reduce the cooling effect.
– I
F POSSIBLE
HAVE TO OPEN THE RADIATOR CAP
THE CAP AND OPEN SLOWLY TO RELEASE PRESSURE
– D
HOT COOLANT AND THE STEAM MAY CAUSE SERIOUS BURNS
– I
N CASE YOU GET BURNT
COLD WATER RIGHT AWAY
– C
OOLANT IS TOXIC
– I
N CASE COOLANT IS INGESTED
– I
F COOLANT GETS INTO YOUR EYES
AND GO SEE A DOCTOR
A mixture of 40% anti freeze liquid and 60% water is used as coolant.
However, the anti-freeze protection must be at least -25° C (-13° F). This
mixture offers anti-freeze protection but also good corrosion protection and
should therefore not be replaced by pure water.
F
OR THE COOLING SYSTEM
A
DVANCE
SION AND COOLANT FOAMING
Pressure induced by heating of the coolant in the system is controlled by a
valve in the radiator cap
admissible therefore, having to expect any trouble.
1
and tilt headlight mask to the front. Remove
2
and remove rubber cap
WARNING
,
ALWAYS CHECK LEVEL OF COOLING LIQUID WHEN ENGINE IS COLD
7
O NOT DETACH ANY RADIATOR HOSES WHILE THE ENGINE IS HOT
,
HOLD THE AFFECTED PART OF YOUR BODY UNDER RUNNING
!
. K
EEP THE COOLANT OUT OF THE REACH OF CHILDREN
,
GO SEE A DOCTOR IMMEDIATELY
!
CAUTION
!
,
USE ONLY WITH HIGH
C
). U
-
OOLANT
SING LOWER
GRADE ANTIFREEZE AGENTS
.
7
; a water temperature of up to 120° C (248° F) is
3
. Turn the supporting ring counter-
4
5
fit into the recess
. Do not touch
6
so that the engine reaches
,
WHEN THE ENGINE IS HOT
USE A RAG TO COVER
. C
-
AUTION
SCALDING HAZARD
. T
.
!
,
RINSE THEM OUT WITH WATER IMMEDIATELY
!
-
GRADE ANTIFREEZE
,
CAN CAUSE CORRO
. I
F YOU
!
HE ESCAPING
!
(
.
. S
I
E
HELL
-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents