Husqvarna SMB 70, SMB 70 E Operator's Manual page 28

!
WARNING!
Check during sawing that the
bandsaw blade does not hit the
folding stops or log lock.
!
WARNING!
The saw carriage must not be
moved backwards while the
bandsaw blade is in motion.
Otherwise the bandsaw can
jump off and cause personal
injury.
Starting the Petrol Engine
1. Start the engine. See page 24.
Starting the Electric Motor
1. Start the electric motor. See page 25.
Sawing
2. Move the saw carriage forwards and cut off
the sapwood.
3. Remove the sapwood.
4. Loosen the log, turn it 180°, lower the height
adjuster (B), and secure the log.
5. Set the required cutting height using the
height adjustment crank (B). This determines
the width of the board.
6. Set the band guide as close as possible to
the log without the log and band guide
touching each other. Lock the band guide
using its lever.
7. Cut off the sapwood on the other side. See p
2 and 3.
28
– English
USE
FIG. 49
FIG. 50