Advertisement
Chain saw
266
model
TECHNICAL SPECIFICATION
Displacement . . . . 66.7 cm
Bore . . . . . . . . . . . 50 mm
Stroke . . . . . . . . . . 34 mm
Ignition advance . . . . . 25˚ before t.d.c. at 8500 rpm
Sparking Plug . . . .
Champion CJ 7Y, PAL P8Y
Electrode gap . . . . 0.5 mm
Carburettor . . . . . . Diaphragm type
Tillotson HS 163 A
Operator's manual
3
Fuel tank capacity . . . .0.75 l
Oil tank capacity . . . . . 0.45 l
Sawing chain. . . . . . .3/8" pitch
Guide Bar . . . . . . . . . . 15"
Weight empty, incl. 15"
guide bar , chain . . . . . 7.0 kg (SE)
and chain brake . . . . . 7.4 kg (SG)
101 84 00-26 B
Advertisement
Table of Contents
Related Manuals for Husqvarna CHAIN SAW 266
Summary of Contents for Husqvarna CHAIN SAW 266
-
Page 1: Chain Saw
Chain saw model TECHNICAL SPECIFICATION Displacement ..66.7 cm Bore ... 50 mm Stroke ..34 mm Ignition advance ..25˚ before t.d.c. at 8500 rpm Sparking Plug . -
Page 2: What Is What On The Chain Saw
“wintergrade” stays fluent even when cold. Concerning the choice ability at different air temperatures, please refer to your Husqvarna use gear box oil type waste oil should be used as this can damage Twostroke Oil 1:50 (270). twostroke... -
Page 3: Maintenance Of The Chain Brake
Chain brake activator “Swed-o-Matic” The Swed-o-Matic should release the chain brake at a certain on the guide bar tip. Adjusting the release power The distance between the Swed-o-Matic front handle (B) determines the release power. A smaller gap means reduced release power. -
Page 4: Starting The Chain Saw
Starting the chain saw A. Cold engine 1. Switch on the ignition (push the switch is visible). 2. Pull out the choke control. 3. Push down the throttle trigger lockout 4. Open the throttle fully (B). 5. Push the throttle latch backwards (C). -
Page 5: Cleaning The Air Filter
Cleaning the air filter A clean air filter is necessary for optimal optimal engine power. In order to get at the air filter, remove the cylinder the retaining screws and lifting the cover off upwards-backwards. Remove the heaviest dirt from the air filter. Undo the screw and lift the filter off carefully to prevent dirt from falling down into the... -
Page 6: Winter Use
Assemble the remaining parts in reverse order Lift up the starter cord into the notch on the pulley. Tension return spring by turning the pulley clockwise NOTE! Make sure that it is possible to turn the pu//ey at least 1/4 of a turn further when the cord is fu//y pu//ed out. - Page 7 Maintenance of the chain saw Daily maintenance 1. Clean the saw body from the outside. 2. Clean the air filter. Change if necessary. 3. Turn around the guide bar, lower edge up. Clean the bar groove. 4. Clean the fan and air intakes in the starter cover. 5.
-
Page 8: Safety Reminders
Safety reminders Handling 1. When transporting the saw, fit the chain protection. 2. Do not smoke when filling the fuel tank. 3. Before cutting, fix the barking support 4. When using the saw, keep both hands on the handles. 5. Nobody is allowed to be within the swing area of the saw.