Sony HDC1500 Series Operation Manual page 16

Rear
The figure shows HDC1500.
a CAMERA POWER switch
a CAMERA POWER switch
CCU: Power supply will be received from the camera
control unit.
EXT: Power supply will be received through the DC IN
connector.
b Tally lamp and switch
ON: The tally lamp lights upon a tally signal input to the
connected camera control unit or a call signal generated
by pressing a CALL button.
OFF: The tally lamp is prevented from lighting.
c CCU (Camera Control Unit) connector (optical/
electrical multi-connector) (HDC1500/1400)
Connect a camera control unit using an optical electro-
composite cable.
3 HDCU/HDFX (HD Triax CCU) connector (Triax
connector) (HDC1550/1450)
Connect the HDFX100 HD Triax CCU Adaptor using a
Triax cable. A camera control unit can be connected via the
HDFX100.
b Tally lamp and switch
Shoulder strap fitting post (page 67)
Operation panel (page 72, page 73)
c CCU connector (HDC1500/1400)
HDCU/HDFX connector (HDC1550/
1450)
d SDI 1 connector (HDC1500 only)
e PROMPTER2 connector
(HDC1500 only)
f Connector panel (page 74)
g CALL button
d SDI 1 (serial digital interface 1) connector (BNC
type) (HDC1500 only)
Used for HD SDI signal output.
e PROMPTER2 connector (BNC type) (HDC1500
only)
Used for prompter 2 signal output.
This operates only when a camera control unit having a
prompter 2 input is connected.
f CALL button
When you press this button, the red tally lamp of the RCP-
700/900-series Remote Control Panel or the MSU-900/950
Master Setup Unit, will light. Use to call the operator of the
RCP or MSU.
Locations and Functions of Parts
71