Advertisement
When installing the GPS Module to work with your TV or MESA system it must be placed in a location
that can give it an unobstructed view of the sky.
DO NOT
• Do not place the GPS Module under the dish or any object that can block the GPS signal
reception from the satellites.
• Do not place in a location subject to standing water.
• Do not install the splitter where water damage could occur.
DO
• Protect all outside coax connections from moisture using a form of dielectric grease.
• Secure all coax connections properly.
• Read all instructions before beginning.
Nomad SD/SD2
• If the controller is configured for SHAW Direct and no GPS detected is detected upon POWER
UP sequence the
Probable Cause
1. Splitter installed improperly
2. Splitter bad
3. No GPS installed
4. GPS not connected to Nomad
5. GPS is bad
• If the controller is configured for other than SHAW Direct then the above still applies. SHAW
Direct software version 1000 and above requires that a GPS be installed.
INSTALLATION
TIPS
ERROR CODES
FIND LED will blink 22 times
-
-
-
-
-
and repeat indicating "No GPS Detected".
Refer to Installation Diagram
Check for voltage at the GPS/Mount
Contact installing dealer
Refer to Installation Diagram
Replace GPS
9
Advertisement
