Advertisement
For use with NOMAD 3, SD/SD2 or MESA Controllers ONLY
Note: For TV - Nomad 3 Software version 37.6 and Nomad SD/SD2 Version 27 (or greater) is required.
MESA
Use any connection To LNB except noted
TV
below.
Note:
When using the DP-3 Dish
Network LNB the 1
left (coded white) can only be used for
External Dish "IN". It is not an "output"
from LNB" connection.
The GPS Module should be placed in an area that is not covered at any time so that it can
receive GPS satellite signals.
The GPS Module must be mounted onto the coax that is in a direct line from mount to the
Nomad 3, SD/SD2 or MESA Controller. The GPS Module is powered by the satellite
receiver or MESA Controller and it must be in line for proper operation.
The High Frequency Splitter must be connected in the above manner and mounted in such
a way as to keep it out of standing water.
TV
For
application the Splitter can be connected to any connector at the base of the dish
with exception of position 4 but it must go eventually through the Nomad 3, SD or SD2
Controller to the satellite receiver.
MESA
For
application the splitter must be placed onto the LNB line.
Apply Dielectric grease to all exposed connections to protect from the elements.
GPS
GPS Module
st
connection on the
LAYOUT
Splitter
4
To Satellite receiver
or Modem
To Satellite receiver
or Modem
Advertisement
