Advertisement
Nomad 3, SD, SD2 or MESA
The Rear Panel consists of a plug in connections Main Power and Motor Control Cable
(optional with the MESA) and F-Connectors To TV Receiver or Internet Modem and To TV
Mount or Internet LNB.
DC Voltage:
This connection provides the +12 or +15 volt DC input power to the
controller.
Control Cable:
This connection sends power to the motors and receives positioning
.
To TV Receiver or Internet Modem:
This connector provides power to the GPS Module from the satellite receiver.
When used on the MESA Controller, the controller provides the power to the
GPS Module.
To TV Mount or Internet LNB:
This connector provides connection to the mount by way of the High
Frequency splitter and receives both GPS data and the LNB signal from
the mount.
TV NOTE: For
DirecTV
Converter (BBC) between the Nomad Controller and the mount. For DirecTV receivers with
'built in' B-Band Converters do not run the coax from the Nomad controller to the receiver.
For
Dish Network
Receivers that use a Separator, install it between the Nomad Controller and
the receiver.
REAR VIEW
12 VDC
Control Cable
or 15 VDC (Optional with the MESA)
CONNECTIONS
data from the mount. (Optional with the MESA)
5 LNB Slim Line High Definition Receivers, install the B-Band
To TV Receiver
Or Internet Modem
5
To TV Mount
or Internet LNB
Advertisement
