Related Manuals for MotoSAT GPS
Summary of Contents for MotoSAT GPS
- Page 1 INSTALLATION & USER GUIDE Compatible with the following controllers Internet Nomad 3 MESA Nomad SD/SD2 Rev 03.25.11 ALL RIGHTS RESERVED...
-
Page 2: Table Of Contents
INDEX BILL OF MATERIALS Components for configuration BLOCK DIAGRAM OF INSTALLATION CONTROLLERS Rear View and Definitions OPERATION MESA GPS OPERATION INSTALLATION TIPS /ERROR CODES INSTALLATION PICTURES GPS WIRING DIAGRAM CONTACT INFORMATION... - Page 3 GPS Assembly Pictures 1. How the GPS Assembly is shipped. 2. Components that go into a GPS Kit. (Mounting Bracket, GPS Module (PC Board) 3. Splitter (voltage passing from the single port side through to the dual port side) Part Number...
- Page 4 External Dish “IN”. It is not an “output” from LNB” connection. The GPS Module should be placed in an area that is not covered at any time so that it can receive GPS satellite signals. The GPS Module must be mounted onto the coax that is in a direct line from mount to the Nomad 3, SD/SD2 or MESA Controller.
- Page 5 (Optional with the MESA) To TV Receiver or Internet Modem: This connector provides power to the GPS Module from the satellite receiver. When used on the MESA Controller, the controller provides the power to the GPS Module.
-
Page 6: Operation
DVB LED goes out. You may do this because the receiver has been powering the GPS device and the GPS has been storing valid data. If you want to make sure that valid data has been received by the GPS then do the following: •... -
Page 7: Mesa
• Press the FIND button and the dish will begin its search routine and locate the preprogrammed satellite. • If the FIND button is depressed before the GPS LED is on solid the system will not activate until it does or if no GPS information is received within 5 minutes the system will activate and use the GPS information that was stored previously and use that data to acquire the targeted satellite. - Page 8 Nomad SD or SD2 controller. To receive power from the satellite receiver it must be plugged in and sending power to the GPS by way of the Nomad SD or SD2 Controller for it to receive the GPS satellite coordinates. Note: the Nomad SD or SD2 Controller does not have to be powered on.
-
Page 9: Installation Tips /Error Codes
INSTALLATION TIPS When installing the GPS Module to work with your TV or MESA system it must be placed in a location that can give it an unobstructed view of the sky. DO NOT • Do not place the GPS Module under the dish or any object that can block the GPS signal reception from the satellites. - Page 10 Sample TV Installation...
-
Page 11: Gps Wiring Diagram
GPS WIRING DIAGRAM MESA Mount TV Mount This splitter is Voltage passing ONE WAY Splitter In from LNB CONTROLLER... - Page 12 For additional information at this time contact MotoSAT Technical Support @ 800-247-7486 Thank you for your assistance, Your Friends at MotoSAT otoSAT 1955 South Milestone Dr. Salt Lake City, UT 84104 Tele 800-247-7486 Fax 801-972-5407 www.motosat.com...