Transparent Mode Internet Access - D-Link DFL-1660 User Manual

4.7.2. Enabling Internet Access
Transparent Mode with a common address range (in this example 192.168.10.0/24).
Figure 4.13. Transparent Mode Internet Access
In this situation, any "normal" non-switch all-nets routes in the routing table should be removed and
replaced with an all-nets switch route (not doing this is a common mistake during setup). This
switch route will allow traffic from the local users on Ethernet network pn2 to find the ISP gateway.
These same users should also configure the Internet gateway on their local computers to be the ISPs
gateway address. In non-transparent mode the user's gateway IP would be the NetDefend Firewall's
IP address but in transparent mode the ISP's gateway is on the same logical IP network as the users
and will therefore be gw-ip.
NetDefendOS May Also Need Internet Access
The NetDefend Firewall also needs to find the public Internet if it is to perform NetDefendOS
functions such as DNS lookup, Web Content Filtering or Anti-Virus and IDP updating. To allow
this, individual "normal" non-switch routes need to be set up in the routing table for each IP address
specifying the interface which leads to the ISP and the ISPs gateway IP address.
If the IP addresses that need to be reached by NetDefendOS are 85.12.184.39 and 194.142.215.15
then the complete routing table for the above example would be:
Route type
Switch
Switch
Non-switch
Non-switch
The appropriate IP rules will also need to be added to the IP rule set to allow Internet access through
the NetDefend Firewall.
Grouping IP Addresses
It can be quicker when dealing with many IP addresses to group all the addresses into a single group
IP object and then use that object in a single defined route. In the above example, 85.12.184.39 and
194.142.215.15 could be grouped into a single object in this way.
Using NAT
NAT should not be enabled for NetDefendOS in Transparent Mode since, as explained previously,
the NetDefend Firewall is acting like a level 2 switch and address translation is done at the higher IP
OSI layer.
Interface Destination
if1
if2
if1 85.12.184.39
if1 194.142.215.15
179
Chapter 4. Routing
Gateway
all-nets
all-nets
gw-ip
gw-ip