Radius Accounting Server Setup - D-Link DFL-1660 User Manual

2.3.10. RADIUS Advanced Settings
continue to be logged in.
Disabling the setting will mean that the user will be logged out if the RADIUS accounting server
cannot be reached even though the user has been previously authenticated.
Default: Enabled
Logout at shutdown
If there is an orderly shutdown of the NetDefend Firewall by the administrator, then NetDefendOS
will delay the shutdown until it has sent RADIUS accounting STOP messages to any configured
RADIUS server.
If this option is not enabled, NetDefendOS will shutdown even though there may be RADIUS
accounting sessions that have not been correctly terminated. This could lead to the situation that the
RADIUS server will assume users are still logged in even though their sessions have been
terminated.
Default: Enabled
Maximum Radius Contexts
The maximum number of contexts allowed with RADIUS. This applies to RADIUS use with both
accounting and authentication.
Default: 1024
Example 2.13. RADIUS Accounting Server Setup
This example shows configuring of a local RADIUS server known as radius-accounting with IP address
123.04.03.01 using port 1813.
Web Interface
1. Go to User Authentication > Accounting Servers > Add > Radius Server
2. Now enter:
• Name: radius-accounting
• IP Address: 123.04.03.01
• Port: 1813
• Retry Timeout: 2
• Shared Secret:enter a password
• Confirm Secret:re-enter the password
• Routing Table: main
3. Click OK
Chapter 2. Management and Maintenance
60