Advertisement
Operation
Priming Pump:
a) In a flooded suction system (water source higher than pump), the pump will fill
itself with water when suction and discharge valves are opened. Water will be at
the top of the hair and lint pot lid.
b) If pump is not in a flooded suction system, unscrew and remove hair and lint pot
lid; fill pot (casing & bowl assembly) with water.
c) Clean, inspect and lubricate 'O'ring; reinstall 'O'ring onto bowl assembly.
d) Replace lid onto bowl assembly; turn clockwise to tighten lid.
Tighten lid by hand only (no wrenches)!
Do not run pump dry or damage will occur and
may void warranty.
Start-up Procedure:
1) Release all air from filter and piping system: see filter owner's manual.
2) Turn pump "ON" at power point or controller.
3) Pump should prime now. Priming time will depend on vertical length of suction lift
and horizontal length of suction piping.
If pump does not prime within a few minutes, make sure that all valves are open,
suction pipe end is under water and that there are no leaks in suction pipe. Ensure
the skimmer basket on pool is clean and free of debris. Repeat step a) - d) under
the section Priming Pump. If the pump still does not prime non return valves may
be required refer to place of purchase for assistance.
7
Hide quick links:
Advertisement
