Zulu2 And Print Only Mode; Zulu2 Robotics Utilities; Enable Configure Dialog; Exercise Belts - MicroBoards Technology CX-1 User Manual

Zulu2 and Print Only Mode

While the CX-1 Disc Publisher was designed to be operated in Burn and Print mode, you can also
use the CX-1 as a disc printer. SureThing Disc Labeler software is included with the CX-1 Disc
Publisher, but you can print using many applications. The image being printed should always be
120mm by 120mm.
Selecting the Print Only option in the Robotics menu will launch SureThing. You will be able to print
directly from SureThing.
While Zulu2 is actively running a Zulu2 action, the robotics will be controlled solely through Zulu2; any
other application will not cause the printer to load a disc to be printed.
If Zulu2 is not closed correctly for whatever reason, the robotics may not be released and discs may
not be loaded onto the belt from the input hopper. If this should occur, simply go into the Robotics
menu and select Utilities.
Click the Print Only Mode button to force Zulu2 to release the robotics. Please note that if you start
another Zulu2 action, the robotics will be controlled through Zulu2 again.
Click OK to close the Utilities.

Zulu2 Robotics Utilities

Aside from the Print Only Mode button described
above, there are 3 other utilities available.

Enable Configure Dialog

Checking this option will enable the Zulu2
configuration dialog.

Exercise Belts

This function will operate in the same manner as
the Exercise Belts button in the Toolbox. See page
17.

Unload the Drive

This function will unload the CX-1 drive and reject
any disc unloaded.
20