Safety Instructions - SELFSAT H21D2+ User Manual

Safety Instructions

• Before using this product please read this manual carefully and follow exactly all installation,
mounting & orientation instructions.
• All the instructions should be followed in order to avoid any technical problems.
• Any electric or magnetic field close to the SELFSAT-H21D+ / H30D+ may cause a bad reception or
even cut off the signal completely.
• Do not drill the plastic cover of the antenna, which seals the antenna from moisture.
• Handle the antenna with care as any impact will cause damage to the electronics.
• Do not open the cover, any attempt to repair by a non-qualified person can be dangerous and void
the warranty.
• Any obstacle (buildings, trees, etc....) will block the reception of the signal from the satellite to the
antenna.
• Do not paint or add any substance on the antenna cover, this will block the reception of the signal
from the satellite.
• The cable between the antenna and the Satellite receiver should not exceed 30m as it will decrease
the quality of the signal.
• The use non- isolated jacks will result in a loss of the signal level.
• Do not forget to adjust the antenna and the bracket to the cross-polarity
• Tighten all the screws of the antenna once you have finished the adjustments.
• This product contains one universal LNB, it is forbidden to add, change or modify the LNB.
• For more precise details on the above points or for any information, please ask your retailer or
customer service.
Antennas improperly installed or installed to an inadequate structure are very susceptible to
wind damage. This damage can be very serious or even life threatening. The owner and installer
assumes full responsibility that the installation is structurally sound to support all loads (weight,
wind & ice) and properly sealed against leaks. The manufacturer will not accept liability for any
damage caused by a satellite system due to the many unknown variable applications.
Warning
www.self-sat.com
4