SoftBank 106SH User Manual page 120

118
Charging Precautions
・Battery and optional accessories are not water or dust
proof. Avoid moisture (precipitation, bath/shower, etc.);
may cause fire, electric shock or damage.
・Never charge Battery while handset is wet; may cause fire
or damage due to electric shock or short-circuit.
・Close Port Cover firmly after charging.
・Do not touch Charger with wet hands. Electric shock may
occur.
・Do not use Charger in rooms in which water is regularly in
use (kitchens, bath/shower rooms, etc.); may cause fire or
electric shock.
・Should External Device Port be exposed to liquid, never
charge Battery; follow these steps first:
1 Holding handset firmly by its sides, shake it about 20
times
2 Pat against dry cloth to remove moisture from External
Device Port
3 Leave handset on dry cloth for approximately 2 - 3 hours
at room temperature
Care & Maintenance
・Proper care of Port Cover gasket and Battery Cover gasket
(for battery housing area) is crucial for continued handset
water/dust resistance. Observe the following:
・Do not remove or damage gaskets. Keep them clean.
・Do not insert sharp objects through Port/Battery Cover
gaps or Headphone Port; may damage gasket and affect
water/dust resistance.
・If Port Cover gasket or Battery Cover gasket (for battery
housing area) is damaged or deformed, contact a SoftBank
Shop.
・To maintain water/dust resistance, replace related parts
every two years regardless of their condition. Customer-
requested parts replacement incurs fees and requires
handset submission. For details, contact a SoftBank Shop or
SoftBank Customer Support, General Information.
Washing Handset
Wipe off dirt, sand, beverage, etc., gently with cloth. Then
with Battery Cover closed, hold handset approximately 10
cm below faucet or shower head and wash with low-pressure
tap water (6 liters/min. or lower) at normal temperature
(5 C - 35 C). Wash with your hands, taking care not to open
o o
Battery Cover and Port Cover; do not use a brush or sponge.
Dry handset before use.
・Before washing handset, make sure that Battery Cover and
Port Cover are closed firmly.
・Do not use a washing machine or ultrasonic cleaner.
・Headphone Port tends to accumulate dust, sand, etc.; rinse
it off and dry Headphone Port completely before use. Any
residue may cause malfunction.
・Do not put a cotton swab, cloth, etc. into Headphone Port;
water/dust resistance may be affected causing malfunction.
・Do not place handset in a microwave oven to dry it.
Battery/handset may leak, burst, overheat or ignite; may
cause malfunction, accident or injury.
・Do not dry handset using extreme heat (hot air from dryers,
etc.); may cause warping, discoloration or damage.
Drying Handset
Dry Headphone Port, Earpiece, Mics, Speaker and Camera
window when exposed to water.
Wipe handset surface with dry cloth
Holding handset firmly by its sides, shake it about 20 times
Pat against dry cloth to remove moisture from grooves
・Do not put a cotton swab, cloth, etc. into the opening.
Leave handset on dry cloth for approximately 2 - 3 hours at
room temperature