Storage; Troubleshooting - Ariens WAW 1034 Owner's/Operator's Manual

Wide area walk mower
Table of Contents

Advertisement

CAUTION: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT: NEVER spray unit with high-
pressure water or store unit outdoors. Store
mower in a cool, dry, protected location.
Cleaning
NOTE: Allow unit to cool before cleaning.
Clean unit thoroughly with mild soap and low
pressure water. Brush off dirt and debris from
all surfaces. Touch up all scratched surfaces
to prevent rust. Matching touch-up paint is
available from your Ariens Dealer. Do not use
abrasives, solvents, or harsh cleaners.
Inspection
Inspect mower and repair or replace worn or
damaged parts to avoid delays when
beginning use again.
Regularly check all hardware and keep
fasteners tight. Know unit is in safe working
condition.
Grass Bag
Wash out grass bag and allow to dry before
storage. Grass bag may be stored in position
on mower.
PROBLEM
Engine will not
start
Engine is
difficult to
restart

STORAGE

TROUBLESHOOTING

PROBABLE CAUSE
1. Safety switch not held down.
2. Ignition switch is faulty.
3. Wiring harness fuse is blown.
4. Loose or corroded battery
cables.
5. Discharged battery.
6. Faulty starter.
1. Out of fuel.
2. Fuel filter is dirty.
3. Faulty spark plug.
4. Air cleaner is plugged or dirty.
5. Faulty engine.
Engine
When storing unit for extended periods of
time, remove all fuel from tank and carburetor
(run dry). Refer to engine manual.
Fuel System
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer according to
manufacturer's instructions.
2. Run engine for at least 10 minutes after
adding stabilizer to allow it to reach the
carburetor.
NEVER store the engine with fuel in the fuel
tank inside of a building with potential
sources of ignition.
CORRECTION
1. Hold down safety switch
2. Replace ignition switch.
3. Replace fuse.
4. Clean and tighten battery
5. Charge the battery.
6. See your Dealer.
1. Fill fuel tank with clean, fresh
2. Replace fuel filter.
3. Replace spark plug.
4. Clean or replace air cleaner.
5. Refer to the engine manual
GB - 22
while turning the ignition key.
cables.
fuel.
or see your Dealer.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

911403911407

Table of Contents