Supports; On-Off Switch; Turning Laser Beam On/Off; Using Your Miter Saw - Terratek PSMS10L User Manual

Supports

Insert supports in both ends of table and secure with screw. (Fig.5)

On-Off Switch

Ensure that the switch is in the "OFF" position. If the plug is connected to a receptacle
while the switch is in the "ON" position, the power tool will start operating immediately
and can cause serious injury.
The on/off switch has a hole to insert a pin (not provided) to avoid accidental starting.
To turn the saw on or off, squeeze and release the on/off switch. (Fig.6)

Turning Laser Beam ON/OFF

CAUTION: LASER RADIATION
Do not stare into beam
To turn on the laser beam, press the upper position (Fig.7) of the switch. Press the
lower position to turn off. Laser line is factory adjusted so that it is positioned within
1 mm (0.04") from the side surface of the blade (cutting position). Make a test cut and
position material to be cut accordingly.
NOTE: When laser line is dim and almost or entirely invisible because of the direct
sunlight, relocate the work area to a place not exposed to the direct sunlight.

Using your miter saw

Important Note:
Transporting or moving this machine must only be done with the arm in the locked position
using the transit lock pin. (Fig.8)
When assembling your machine do not connect to the power supply until you have fully
read and understood this manual. After carrying out all checks and making any necessary
adjustments check that the machine switch is in the off position, connect to the power
supply and then switch the machine on and off quickly, this will allow you to check for
any loose blades or accessories without the machine gaining full speed. Disconnect
from the power supply before attempting any adjustments.
During manufacturing your machine is set and calibrated to cut accurately however
movement can occur during transit. If you find that your machine is not cutting accurately
you can make several small adjustments easily.
Resetting the Table to 90 degrees with the Blade
1. Disconnect the machine from the mains.
2. Lock the arm in the transit position
3. Loosen the Miter Lock Handle. (Fig.9)
4. Depress lock. (Fig.9) A
5. Align the pointer and table to 0 degrees.
6. Tighten the Miter Lock Handle.
7. Loosen the Bevel Lock Handle. (Fig.10)
8. Position the saw arm to 0 degrees with the blade 90 degrees to the table surface.
9. Tighten the Bevel Lock Handle.
13