Additional Safety Rules For Laser - Terratek PSMS10L User Manual

12. While making a slide cut, KICKBACK can occur. KICKBACK occurs when the blade
binds in the workpiece during a cutting operation and the saw blade is driven back
rapidly towards the operator. Loss of control and serious personal injury can result.
If blade begins to bind during a cutting operation, do not continue to cut and release
switch immediately.
13. Use only flanges specified for this tool.
14. Be careful not to damage the arbor, flanges (especially the installing surface) or bolt.
Damage to these parts could result in blade breakage.
15. Make sure that the turn base is properly secured so it will not move during operation.
Use the holes in the base to fasten the saw to a stable work platform or bench.
NEVER use tool where operator positioning would be awkward.
16. For your safety, remove the chips, small pieces, etc. from the table top before
operation.
17. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
operation.
18. Make sure the shaft lock is released before the switch is turned on.
19. Hold the handle firmly. The saw moves up or down slightly during start-up and
stopping.
20. Make sure the blade is not contacting the workpiece before the switch is turned on.
21. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration
or wobbling that could indicate poor installation or a poorly balanced blade.
22. Wait until the blade attains full speed before cutting.
23. Stop operation immediately if you notice anything out of the ordinary.
24. Do not attempt to lock the trigger in the on position.
25. Stay alert. Blades are extremely dangerous
26. Use only accessories recommended in this manual. Use of improper accessories
such as abrasive wheels may cause an injury.
27. NEVER hold workpiece on right side of blade with left hand or vice versa. This is
called cross armed cutting and exposes user to risk of SERIOUS PERSONAL INJURY.
ALWAYS use vise to secure workpiece.
28. Do not abuse cord. Never pull on the cord to disconnect it from the receptacle.
Keep cord away from heat, oil, water and sharp objects.
29. Some materials contain chemicals which may be toxic. Take appropriate measures
to prevent dust inhalation and skin contact. Follow material supplier safety data.

Additional Safety rules for Laser

WARNING: This saw is equipped with a Laser light, DO NOT stare into the beam because
serious injury may occur.
LASER LIGHT - DO NOT STARE INTO BEAM, APERTURE, or into a reflection from
a mirror-like surface.
AVOID EXPOSURE - LASER LIGHT IS EMITTED FROM FRONT GUARD APERTURE.
CAUTION: Use of controls or adjustments, or performance of procedures other than
those specified herein may result in hazardous laser light exposure.
11