Light Bulb Changing - Kenmore 116.22805C Owner's Manual

PIÈCES ET CARACTÉRISTIQUES
Il est important de connaître les pièces et les caractéristiques de l'aspirateur pour l'utiliser correctement et en
toute sécurité. Lire cette section avant de l'utiliser
Objet Pièce Nº.
aux Etats-Unis
Ampoule 20-5240
Courroie 20-5218
Power-Mate®
Tube
télescopique
Collet
Pedale de
relâche de
la rallonge
(Non illustré)
Pédale de
hauteur de poils
Pédale de
relâchement
de manche
Numéros de
modèle/série
Power-Mate (Au bas) ®
Pièce Nº.
au Canadá
20-40600
20-40118
Relâche rapide
Bouton d'ajustement
de longueur du tube
Courroie
Éclairage
Indicateur de
hauteur de poils
Protecteur de
surchage
Bouton de remise
en circuit
Nettoyeur de bords
(Non illustré)
Détecteur de
poussière
4
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path. Motor
Drive
NOTE: See
Belt
PARTS AND
Path
FEATURES
Agitator
End Cap
for belt num-
ber.
2. Place agitator
assembly back into
®
Power-Mate .
3. Line up
front of
cover and
base. Rest
cover on
front edge
of base as
shown.
Base
Cover

LIGHT BULB CHANGING

®
1. Remove Power-Mate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
2. Push in and turn
Push In
And Turn
bulb counterclock-
wise, then pull out
to remove.
4. NOTE: On dirt sensor models be sure
that the board is upright and the wires are
tucked back in place.
5. Rotate
cover back.
Press cover
firmly until side
and rear tabs
Side Rear
snap into place.
Latch Latches
Make sure there is no gap between the
cover and base.
®
6. Turn Power-Mate upside down and
replace two (2) cover screws.
3. Push in and turn
Push In
And Turn bulb clockwise, to
replace. Bulb must
not be higher than
15 Watts(130 Volts).
®
4. Reinstall Power-Mate cover as shown in
BELT CHANGING AND AGITATOR
CLEANING section.
NOTE: See PARTS AND FEATURES for
bulb number.
19