Operation Section - Toshiba MMD-AP0481HFE Owner's Manual

1
2
3
4
5
6
16
8
Set temperature display
The selected set temperature is displayed.
9
Remote controller sensor indicator
Displayed when the remote controller sensor is
used.
10
Pre-heat indicator
Displayed when the heating mode is energized or
defrost cycle is initiated.
While this indication is displayed, the indoor fan
stops or operate in fan mode.
11
No function indicator
Displayed when the function requested is not
available on that model.
12
Fan speed indicator
Fan speed is fixed and the indicator is fixed to
" High".
13
Central control indicator
Displayed when the air conditioner is controlled
centrally and used with central control devices
such as the central remote controller.
If the use of the remote controller is prohibited by
the central control, blinks when the ON/OFF,
MODE, or TEMP. button on the remote controller
is pushed, and the buttons do not function.
(Settings that can be configured on the remote
controller differ depending on the mode of the
central control. For details, read the Owner's
Manual of the central remote controller.)
14
Operation mode controlled indicator
Displayed when MODE button is pushed while
operation mode is fixed to cool or heat by the air
conditioner administrator.
15
Operation ready display
This display appears on some models.
9-EN
13
7
8
9
10
12
16
Service display
Displayed while the protective device works or an
error occurs.
– 5 –

Operation section

Once the settings have been configured, all you need to do is push the
14
15
11
1
button (Fan speed select button)
Only "High" is displayed.
2
button (Timer set button)
Use to setup the timer.
3
button (TEST button)
Use only for service.
(During normal operation, do not use this button.)
4
button
Use when a ventilator (commercially-available) is
connected. Push the button to turn ON/OFF the
ventilator. Turning ON/OFF the air-conditioner
also turns ON/OFF the ventilator.
No ventilator is connected if "
*
the remote controller display after pushing the
button.
5
button (Filter reset button)
Resets "
6
button (Power save operation)
No function.
7
SWING/FIX button
No function.
8
Operation lamp
Lights up during running.
Blinks when an error occurs or the protective
device activates.
9
button
Turns on the unit when pushed, and turns off when
pushed again.
1 8
12
2
5
3
7
10
Selects desired operation mode.
11
UNIT LOUVER
UNIT button:
No function.
LOUVER button:
No function.
12
Adjusts the set temperature.
Select the desired set point by pushing
OPTION:
" appears on
Remote controller sensor
Normally the temperature sensor of the indoor unit
senses the temperature. The temperature around the
remote controller can also be sensed. For details,
contact your dealer.
FILTER" indication after cleaning.
button from then on.
9
10
4
11
6
button (Operation mode select button)
button (Unit / Louver select button)
button
TEMP.
or TEMP.
10-EN