Error Analysis - Electrolux COOKERS Service Instructions Manual

4.

Error analysis

Coil left
Module left
Error indications/
Error analysis
E0
E1
E2
E3
E4
E5
E6
E7
E8
E9
No pot detection on L.H.
hot plate
No pot detection on
central hot plate
No pot detection on R.H.
hot plate
No indication on R.H. hot
plate
Indication above L.H. hot
plate is lit
Central indication off and
R.H. indication "E" (E4)
R.H. indication "E" (E4)
DGS-TDS-N 11.08 U.H. © Electrolux
Coil middle
Module middle
Error Cause
Incorrect or incomplete configuration
Internal electronic error
Pot detection
Excess voltage --> 400V
Sensor not plugged or defect. Connections not
reserved
Zero crossing of the mains voltage
incompatible
Defect in the communication to the power
board
Sensor on heat sink defect
Communication between induction and
interface in failure
Configuration data for interface incompatible
Phase or neutral for L.H. module not
connected or available
Phase or neutral for module not connected or
available
Connecting line between modules missing or
defect
L.H. module not programmed
Both modules not programmed
Right module not programmed, sensor for the
right cooking plate defective
- 11 -
Error code timer
Coil right
Module right
Check connection
Install new power
Install new input
Check connection
Check connection
Install new filters
Install new filter.
Error Remedy
Install new filter
Install new filter
Install new filter
Install new coil
Check mains
Install new filter
electronics
electronics
Install new filter
Replace line
Install new filter
Replace coil
599 529 016 EN