Error Codes Induction Hobs; Error Codes For Cooking Hobs With Radiant Heating - Electrolux COOKERS Service Manual

4.4

Error Codes induction hobs

Error in the
timer display
E0
E1
E2
E3
E4
E5
E6
E7
E8
E9
Remark for hobs with left and right interface:
If a Error occurs the hob switches off automatically. Switch the hob on again the error is
displayed again. Afterwards the Error disaapears and the defect side is shown by the displays
"?" for bargraph or "E" in the 7-segment displayes.
4.5

Error Codes for cooking hobs with radiant heating

Error in the
timer display
E0
E1
E2
E3
E4
E5
E6
E7
E8
E9
DGS-TDS-N 12.08 U. H. / A. B. © Electrolux
Failure
Configuration Error of
Interface
Compatibilty failure
n/a
Overvoltage; wrong
connection
Temperature sensor coil
defect
Supply voltage out of range
Induction module defect
"E7" in Timer display +
"E" or "?"in the left zones
"E7" in Timer display +
"E" or "?"in the right zones
Communication error with
the power board
Internal interface error
Failure
Configuration Error of
Interface
Compatibilty failure
Pot detection error
n/a
n/a
Supply voltage out of range,
one phase missing
Induction module defect
"E7" in Timer display +
"E" or "?"in the left zone
Communication error with
the power board
Internal interface error
Liquid blocks interface
- 10 -
Solution for 5-zone induction
Exchange Interfaces
Exchange Interfaces
-
Check power supply
The zone with the defect sensor
displays "E" or "?"
Change the Coil of the displayed
zone
1. Check Voltage and
Frequency
2. Exchange module left side
Change module left with power
supply
Change induction module on the
left side
Change iduction module on the
right side
1. Check supply connection
2. Check wiring between
interface and power
board
3. Change induction module
Exchange interface with silicone
carrier
Solution
Exchange Interfaces
Exchange Interfaces
If pot detection is available
change Pot detection electronic
-
-
1. Check Voltage and
Frequency
2. Exchange module right side
Change module left with power
supply
Exchange displayed heater with
pot detection senor and calibrate
new
1. Check supply connection
2. Check wiring between
interface and power board
3. Change induction module
Exchange interface with silicone
carrier
599 714 137 EN