Table of Contents
Advertisement
V-Stick Functions
The "V-Stick" is located to the upper right of the jog/shuttle
control. It is a soft, four position switch. The switch is activated by
applying pressure either left, right, toward you, or away from you.
It is not necessary to press down or rotate the control.
It performs the following functions:
V Stick Down = Reverse 2x
V Stick Up = Forward 2x
Locate Functions
The MCS3-SP can capture and store timecode locations for later
recall. It can do this either on the fly (program is playing) or while
stationary (program is stopped). Locates are captured and stored
by holding the Record button and pressing W1 thru W6. A
timecode request will be sent, and the responding timecode will be
stored within the MCS3-SP. Because the MCS3-SP does not have
nonvolitile ot battery backed memory, the locate points will be
stored until power is removed from the MCS3-SP. The MCS3-SP
can store up to six locate points:
W1 = Locate 1
W2 = Locate 2
Stored Locate Points are recalled by pressing the W1-W6 buttons.
After power up, all locate points are initialized to 00:00:00:00.
Pressing a locate button without first storing a locate point will
cause the deck to go to 00:00:00:00. The W7 button sends a pause
command.
Note: Locate Points are not retained when the MCS3-SP is turned off
V Stick Left = Reverse 1x
V Stick Right = Forward 1x
W3 = Locate 3
W4 = Locate 4
9
W5 = Locate 5
W6 = Locate 6
Advertisement
Table of Contents
