Attaching The Unit To A Wall (Optional) - Panasonic SC-NE3 Operating Instructions Manual

Messages
The following messages or service numbers may
appear on the unit's display.
"AUTO OFF"
≥ The unit has been left unused for about 30 minutes and will shut
down within a minute. Press any button to cancel it.
"DL ERROR"
≥ The software download has failed. Press any button to exit.
Please try again later.
≥ The server cannot be found. Press any button to exit. Make sure
that the wireless network is connected to the Internet.
"ERROR"
≥ Incorrect operation is performed. Read the instructions and try
again.
"F " (" " stands for a number.)
≥ There is a problem with this unit.
Note down the displayed number, disconnect the AC mains lead
and consult your dealer.
"FAIL"
≥ Updating or setting has failed. Read the instructions and try again.
"LEVEL 0"
≥ There is no link between this unit and the wireless network router.
Try the following operations:
– Check that the wireless network router is turned on.
– Turn this unit off and on again.
– Reset the wireless network settings. (l 7)
If the problem persists, consult your dealer.
"LEVEL j"
≥ When "D.CONNECT" is set to "ON" the Wi-Fi signal strength
cannot be checked. To check the Wi-Fi signal strength from the
wireless network router, set "D.CONNECT" to "OFF". (l 10)
"LINKING"
≥ This unit is communicating with the wireless network router
to complete the network settings.
Depending on the wireless network router this process may
take a few minutes. Try moving this unit closer to the wireless
network router.
"NOCONNECT"
≥ This unit is not connected to the network.
Check the network connection. (l 7)
"REMOTE " ("
≥ The remote control and this unit are using different codes. Change
the code on the remote control.
– When "REMOTE 1" is displayed, press and hold [OK] and
[ , AUX] for more than 4 seconds.
– When "REMOTE 2" is displayed, press and hold [OK] and
[SOUND] for more than 4 seconds.
16
VQT4U51
" stands for a number.)
Attaching the unit to a wall
(optional)
This unit can be wall mounted using the supplied wall
mount brackets, etc. Make sure that the screw used
and the wall are strong enough to support the weight of
at least 33 kg.
The screws and other items are not supplied as the
type and size will vary with each installation.
≥ Refer to step 2 of "Wall mount instructions" for details
about the required screws.
≥ Be sure to attach the fall prevention cord as a
secondary safety measure.
Installation accessories
∫ Supplied accessories
≥ 1 Safety holder
≥ 1 Screw
≥ 2 Wall mount brackets
∫ Additionally required accessories
(commercially available)
≥ 4 Wall mount bracket fixing screws
≥ 1 Safety holder fixing screw
≥ 1 Fall prevention cord*
≥ 1 Screw eye
* Use a cord that is capable of supporting over 33 kg
(with a diameter of about 1.5 mm).
≥ Keep the safety holder out of reach of children to
prevent swallowing.
≥ Keep the screws out of reach of children to prevent
swallowing.
≥ Keep the wall mount brackets out of reach of children
to prevent swallowing.
Safety precautions
Professional installation is required.
The installation should never be done by any
other than a qualified installation specialist.
PANASONIC DISCLAIMS ANY PROPERTY
DAMAGE AND/OR SERIOUS INJURY,
INCLUDING DEATH RESULTING FROM
IMPROPER INSTALLATION OR INCORRECT
HANDLING.
≥ Be sure to install this unit as indicated within
these operating instructions.