Software Update - Panasonic SC-NE3 Operating Instructions Manual

Software update

Occasionally, Panasonic may release updated
software for this unit that may add or improve the way
a feature operates. These updates are available free of
charge.
Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (l 7)
– Make sure that the wireless network is connected
to the Internet.
– If "D.CONNECT" is set to "ON", change the setting
to "OFF" and connect this unit to a wireless
network that is connected to the Internet.
1
Press [SETUP] repeatedly to select
"SW UPDATE" and then press [OK].
2
Press [3, 4] to select "UPDATE? Y" and then
press [OK] to start the update.
DO NOT DISCONNECT the AC mains lead while
one of the following messages is displayed.
– "LINKING", "UPDATING" or "
(" " stands for a number.)
≥ During the update process, no other operations can be
performed.
3
When the update has finished successfully,
"SUCCESS" is displayed.
4
Disconnect the AC mains lead and reconnect it
after 3 minutes.
≥ Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
≥ If you do not want to update the unit, select "UPDATE? N"
and then press [OK] in step 2.
≥ If there are no updates, "NO NEED" is displayed after step 2.
∫ Checking the software version
1 Press [SETUP] repeatedly to select "SW VER." and then
press [OK].
{. The version of the installed software is displayed.
2 Press [OK] to exit.
14
VQT4U51
%"
Wireless network name (SSID)
Display the name for the connected wireless network
(SSID).
1
Press and hold [– WPS] on the unit and [OK] on
the remote control until the unit's display shows
the SSID.
2
Press [OK] to exit.
≥ If "NOCONNECT" is displayed this unit is not connected to a
wireless network.
≥ All letters are displayed as capital letters, and characters that
cannot be displayed are replaced with "
IP/MAC Address
To check the unit's IP address or the Wi-Fi MAC
address.
1
Press and hold [– WPS] on the unit and [4] on the
remote control until the unit's display shows the IP
address.
{. The IP address is partially displayed.
≥ To display the MAC address on the unit, repeat the
steps above by replacing [4] with [3].
2
Press [3, 4] on the remote control to show the
rest of the IP address.
≥ To exit the setting, wait 20 sec.
≥ The " – " displayed on the top or bottom left of the display
indicate the first and last units respectively.
Changing the unit and remote
control code
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [ , AUX] to select "AUX".
2
While pressing and holding [
press and hold [SOUND] on the remote control
until the unit's display shows "REMOTE 2".
3
Press and hold [OK] and [SOUND] on the remote
control for at least 4 seconds.
≥ To change the mode back to "REMOTE 1", repeat the steps
above but replace the button pressed on the remote control
from [SOUND] to [ , AUX].
¢ ".
/ AUX] on the unit,