Table of Contents
Advertisement
7
INSTALLING BAGGER MOUNT
1. To select the right support straps to use, measure
the mower frame just behind the casters, as
shown.
For frames measuring 26" use support straps A,
for frames measuring 23" use support straps B.
B
A
10
ASSEMBLY
2. Install the bagger mount tube to the rear guard
with
/
5
16
NOTE: Depending on model, rear guard hole may
need to be drilled out to
large.
3. Install kit support straps on the outside of the
mount tube as shown in the illustration. Using a
/
-18 x 1¼ bolt, attach the front side of the strap
5
16
to the fender support. Do not add flange nut at this
time. Place the reinforcement plate to the outside
of the fender support. Secure with additional 1¼
bolt and fasten both bolts with flange nuts. Repeat
steps on opposite side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
4. Tighten all hardware.
Reinforcement Plate
Support Strap
-18 x 3¼ bolts and flange nuts from kit.
/
" if kit hardware is too
5
16
Rear Guard
Mount Tube
Drill rear
guard hole to
/
" if needed
5
16
Advertisement
Table of Contents
