Table of Contents
Advertisement
ARS-2021D/2021DS Manual
Press ENT to enter the next figure. Follow the instructions on LCD to do the button
test. After that, the system will do the self-test of SDRAM, the hardware connection
test and flash test. All test results will be shown on LCD. It is the easiest way to
know if the system can work well.
When the whole process finishes, LCD will show the message as follows.
6.12.10 Load Default
On the above figure press ESC and
make all changed settings recover to defaults.
Press ENT to enter the next figure. Use
↑ ↓ Enter ESC
Holde ESC to exit
Test finished
M
to enter the next figure. Load Default is to
12-10. Adv Setup
Load Default
L M
to confirm Yes or No.
Load Default
Config? Yes
68
Advertisement
Table of Contents
