General Lock WP-380 User Manual

WP-380 Users Manual and Installation Instructions
WP-380 Camera Users Manual and

Installation Instructions

I. General
The WP-380 series of cameras contain a CCD camera in a stylish and attractive
waterproof housing. WP-380 series uses a high sensitive 1/3" color interline transfer
CCD sensor with low lux performance.
II. Precautions
• Do not expose the camera to humidity and dust. If the camera is mounted outdoor,
a camera housing is required.
• Handle with care. This camera consists of high sensitive parts. Do not disassemble
it or place it on an unstable base.
• Do not touch the surface of CCD sensor by hand directly. When the camera is not
in use, put the cover cap on the lens.
• Never face the camera toward the sun.
• Use N.D. filter or set large F number of manual lens when the light intensity is very
high, in order to protect the sensitive CCD sensor.
• Use proper power source otherwise the camera will not function correctly. Operate
on DC +12V (Use a regulated power source only).
III. Part Names
IV. Installation Instructions
1. Connect the camera with the mounting bracket (supplied).
2. Remove the bracket base from the mounting bracket.
3. Using the supplied screws, mount the bracket base in the desired location.
4. Reassemble the bracket with the camera onto the mounting
5. Loosen the swivel screw and then point the camera in the desired direction.
6. Tighten the swivel screw.
7. Connect the BNC connector of the camera to a monitor or other video device
through a 75 ohm type coaxial cable with BNC female connector at cable extension.
8. Connect the DC+12V regulated power source of the camera (DC Jack) to the
DC12V power-in jack with 2mm, center+ outer- plug.