How To Start Your Pressure Washer - Troy-Bilt Pressure Washer Operator's Manual

How to Start Your Pressure Washer

To start your pressure washer for the first time, follow these
instructions step-by-step. This starting information also
applies if you have let the pressure washer sit idle for at least
a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.3 gallons per minute (12.5 liters per minute) and no
less than 20 PSI (1.38 BARS) at pressure washer end
of garden hose. DO NOT siphon supply water.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See Assembly section.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Turn ON water, point spray gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
6. Attach nozzle extension to spray gun. Tighten by hand.
7. Engage trigger lock (A) on spray gun trigger.
8. Move throttle lever (B) to "Fast" position, shown here
as a rabbit.
B
9. Move choke lever (C) to "Choke"
NOTE: For a warm engine, be sure the choke lever is in the
"Run" position.
10. When starting engine, position yourself as
• NEVER pull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt and
then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction and squeeze spray gun trigger
to release high pressure. Engage spray gun trigger lock.
• Firmly grasp spray gun with both hands when using high
A
pressure spray to avoid injury when spray gun kicks back.
11. Return starter grip handle slowly. DO NOT let rope
12. When engine starts, slowly move choke lever to "Run"
13. After each starting attempt, where engine fails to run,
14. If engine fails to start after six pulls, move choke lever
C
NOTE: Always keep the throttle lever in the "Fast"
position.
position when operating the pressure washer.
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine.
WARNING
Starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
"snap back" against starter.
position, as engine warms. If engine falters, move choke
lever to "Choke" position, then to "Run"
always point gun in safe direction and squeeze spray gun
trigger to release high pressure. Move choke lever to
"Choke" position, and repeat steps 10 through 12.
to "Run" position, and repeat steps 10 through 12.
position.
13