To blow away debris on the
ground
Fitting the blower tube and nozzle
on the blower
!
WARNING!
When fitting the blower tube and
nozzle, the engine must be
switched off and the stop switch
must be in the stop position.
The blower tube and nozzle have a bayonet mount.
Fit them in the following manner:
1. Press the blower tube (15) against the blower air
outlet and turn it 90 degrees until a snap is
heard.
2. Fit the nozzle (14) onto the tube (15), and turn it
90 degrees until a snap is heard.
Blowing
Before you begin blowing, put on the required safety
equipment.
!
WARNING!
When working with the blower,
wear the required protecting
equipment:
1.
Hearing protection.
2.
Eye protection.
3.
Face mask in dusty environ-
ments.
When operating the blower, the blower must be
secured to the shoulder strap. The strap should be
worn over the shoulder as shown in the adjacent
figure.
16
– English
USING THE BLOWER
15
14