Engine Coolant - Diesel Vehicles - Husqvarna HUV 5420 DX Owner's Manual

Engine Coolant – Diesel Vehicles
Check the level of lubricant at the level indicator plug (1). Apply Loctite 567 to the threads of the level indicator plug
and tighten to 21 ft-lb (28 N·m).
Rear differential:
Clean and install the drain plug (2) and washer before filling the rear differential with new lubricant (Figure 24). Tighten
the drain plug to 96 in-lb (10.8 N·m). Use a funnel to fill the differential through the lubricant level indicator hole
(1). See Periodic Lubrication Schedule on page 33. Apply Loctite 567 to the threads of the level indicator plug
and tighten to 21 ft-lb (28 N·m).
217
Figure 24 Rear Differential Lubrication Level
ENGINE COOLANT – DIESEL VEHICLES
ENGINE COOLANT LEVEL CHECK
The coolant reserve tank (2) is located under the hood on the passenger side (Figure 14). Raise the hood to check
the coolant level before every operation.
1. Check the coolant level of the reserve tank (2). If the coolant is at or below the LOW mark, add pre-mixed
coolant until the level reaches the FULL mark. If a leak is detected, have it checked by a trained technician.
See following WARNING.
WARNING
• Hot! Coolant reserve tank is pressurized. Do not remove cap when engine is hot.
Page 40 HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner's Manual