Table of Contents
Advertisement
Using A Booster Battery (Jump Starting)
WARNING
• If battery wire terminals are damaged or corroded, replace or clean them as necessary. Failure to do
so may cause them to overheat during operation and could result in a fire, property damage, or
personal injury.
Be sure the battery hold-down clamp is properly tightened. Tighten to 108 in-lb (12.2 N·m). A loose clamp may allow
the battery to become damaged from vibration or jarring.
If battery appears weak, have it charged by a trained technician. The battery should never be left discharged any
longer than absolutely necessary (do not leave discharged overnight).
USING A BOOSTER BATTERY (JUMP STARTING)
WARNING
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear a full face shield and
rubber gloves when working on or near batteries.
• When jumping from a booster battery make final connection (negative) at engine frame.
• Do not jump start or charge a frozen or damaged battery. Unplug charger before connecting or
disconnecting cables to the battery. Never lean over battery while boosting, testing, or charging.
If it is necessary to use a booster battery to start the engine, BE CAREFUL!
1.
Turn the key switch to the OFF position. Place the Forward/Reverse handle in the NEUTRAL position, engage
the park brake, and chock the wheels.
2.
Ensure the booster battery is 12-volt.
3.
Access the engine compartment by raising the cargo bed. See WARNING "For vehicles with cargo beds..." in
General Warnings on page 8.
4.
Locate the vehicle battery on the driver's side of the vehicle under the cargo bed (Figure 30).
5.
Connect the end of the first cable (1) to the positive (+) terminal of the booster battery. Connect the other
end of the same cable (2) to the positive terminal of the vehicle battery. See DANGER "Battery – Explosive
gases!..." in General Warnings on page 8.
6.
Connect the end of the second cable (3) to the negative (–) terminal of the booster battery. Connect the other end
of the same cable (4) to the battery frame ground.
7.
Sit in the driver's seat and start the engine.
8.
After the engine has started, remove the frame ground (–) cable (4) first. Remove the cable from the positive
terminal (2). Then remove the cables from the booster battery. See following CAUTION.
CAUTION
• The alternator can be damaged if the following actions occur:
– Engine is operated with battery cables disconnected.
– Booster cables are connected wrong.
Page 46
HUV 5420 DX All-Wheel Drive CE Mark Diesel Vehicle Owner's Manual
Advertisement
Table of Contents
