Table of Contents
Advertisement
Using the Lighting Stick to Light the Main Burners
1.
Remove the cooking grid and heat plate from the burner you wish to light.
2.
Insert a match into the end of lighting stick. Light the match.
3.
Once lit, place the flame through the hole on grill body to reach the burner ports.
(As in the fig. shown on right).
4.
Press the control knob and rotate it counter clockwise to the ''HIGH'' position.
The burner should light immediately. To light up other burners, repeat the same
procedure for the adjacent burner and continue in sequence until all desired
burners are lit.
5.
Replace cooking grid and heat plate and adjust burners to the desired cooking
temperature.
Precautions
1.
After lighting, please observe the burner flame. Make sure all burner ports are lit.
2.
If the burner flame goes out during operation, immediately turn the gas "OFF". Open lid to let the gas clear for at least
5 minutes before re-lighting.
3.
Before cooking on the grill for the first time, operate the grill for approximately 15 minutes with the lid closed and the
gas turned on "HIGH". This will "heat clean" the internal parts, dissipate odor from the manufacturing process and
painted finish.
4.
Clean the grill after each use. DO NOT use abrasive or flammable cleaners. This may damage parts of the grill and
cause a fire.
Side Burner
1.
Open lid while lighting the burner. Lid must remain open while burner is lit.
2.
Control knob must be in the "OFF" position.
3.
Open cylinder valve.
4.
Automatic ignition: Push desired burner control knob and rotate slowly about 1/4 counter-clockwise until a click is
heard. Push button ignition: Push and turn desired burner control knob to the "High" position and then push the ignitor
button. The burner should light. If the burner does not light, turn the knob to the "OFF" position immediately. Wait five
minutes for the gas to clear and repeat the procedure.
5.
Adjust valve knob to the desired cooking temperature.
Confirm that the burner is properly lit and that the flame pattern is as desired, (see fig. A, B and C below for the proper flame
patterns).If the flame pattern is other than normal, consult the troubleshooting guide in the manual for corrective action.
FIG. A
Normal: Soft blue flames
with yellow tips between 1
inch - 2 inches high.
GSF2616JB
Owner's Manual
2 in.
1 in.
Observe flame height when lit:
0 in.
Flame should be a blue/yellow color between 1 to 2 inches high.
FIG. B
Out of adjustment: Noisy hard
blue flames – too much air.
17
FIG. C
Poor combustion: Wavy,
yellow flames- too little
air.
Advertisement
Table of Contents
