Table of Contents
Advertisement
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC + Blank This selection will cause the system to turn off
Blank Screen
This option only writes blanks to the video buffer.
DPMS
Initializes display power management signaling. Use
this option if your video board supports it.
Video Off After
N/A
The system BIOS will never turn off the screen.
Suspend The screen is off when the system is in the Suspend
mode.
Standby
The screen is off when the system is in the Standby
mode.
MODEM Use IRQ
This category is used to set an IRQ channel (IRQ 3, 4, 5, 7, 9, 10 or
11) for the external modem installed in your system. However, if the
“Resume on Ring” or “Resume on LAN” field is disabled, the BIOS will
mask the IRQ assigned for the modem. This is to prevent the modem
or LAN from waking up the system when it is in the Suspend mode.
Standby Mode
This is user configurable only when the Power Management category
is set to User Defined. When enabled and after the set time of
system inactivity, video will be shut off while all other devices still
operate at full speed.
Suspend Mode
This is user configurable only when the Power Management category
is set to User Defined. When enabled and after the set time of system
inactivity, the CPU and onboard peripherals will be shut off.
HDD Power Down
This is user configurable only when the Power Management category
is set to User Defined. When enabled and after the set time of system
inactivity, the hard disk drive will be powered down while all other
devices remain active.
Award BIOS Setup Utility
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
3
45
Advertisement
Table of Contents
