Winter Preparations - Intex Ultra Frame Owner's Manual

Winterizing your Above Ground Pool
After usage, you can easily empty and store away your pool in a safe
place. Some people however, choose to leave their pool up all year
round. In cold areas, where freezing temperatures occur, there can be
a risk of ice damage to your pool unit. We therefore recommend you to
drain, disassemble and properly store away the unit, when the
temperature drops below 32 degrees Fahrenheit (0 degrees Celsius).
Also see the section ''How To Drain Your Pool''.
Should you choose to leave your pool out, prepare it as follows:
1. Clean the pool water thoroughly. If the type is an Easy Set Pool or an
Oval Frame Pool, make sure that the top ring is properly inflated).
2. Remove the skimmer (if applicable) or any accessories attached to the
threaded strainer connector. Replace strainer grid if necessary. Be sure
all accessories parts are clean and completely dry before storage.
3. Close the Inlet and Outlet Plunger Valve.
4. Remove the ladder (if applicable) and store in a safe place. Be sure the
ladder is completely dry before storage.
5. Remove the hoses that connect the pump and filter to the pool.
6. Add the appropriate chemicals for the winter period. Consult your local
pool dealer as to which chemicals you should use and how to use them.
This can vary greatly per region.
7. Cover pool with Intex Pool Cover. IMPORTANT NOTE: INTEX POOL
COVER IS NOT A SAFETY COVER.
8. Clean and drain the pump, filter housing and hoses. Remove and discard
the old filter cartridge. Keep a spare cartridge for the next season).
9. Bring pump and filter parts indoors and store in a safe and dry area,
preferably between 32 degrees Fahrenheit (0 degrees Celsius) and 104
degrees Fahrenheit (40 degrees Celsius).
SAVE THESE INSTRUCTIONS
(118IO) ULTRA FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 05/22/2009

WINTER PREPARATIONS

118
English
IO
Page 11