Brunton ADC-Summit User Manual page 35

12.6 Temperature Mode -
TEMP 8 C
28.3
18.2 13.2
Temperature Mode
Wind Chill Temperature
Alarm Setting
Alarm OFF
W.CHILL 8 C
[set]
OFF
- - - -
18.3 8.3
hold
[reset]
scroll
the setting
faster
Downloaded from www.Manualslib.com
Wind Chill Temperature Alarm and
hold
Temperature Calibration
[mode]
Setting Sequence
[mode]
Wind Chill
Temperature
Temperature
Calibration
Alarm
hold
[mode]
Temperature
Calibration Display
Alarm ON
TEMP
W.CHILL 8 C
OFFSET
ON
-10.0
18.3
18.3 8.3
flash
[reset] [mode]
Calibration Setting Display
scroll the
setting by
Check 'Calibrating
increment
the Temperature' section
of 1 step
below for more detail
manuals search engine
Setting the Wind Chill Temperature Alarm
To Select Setting Display
!
To select the setting display, press and hold
the [mode] button for about 2 seconds to
select the setting display (temperature digits
will start flashing).
The Setting Sequence
!
When the temperature digits are flashing,
press the [mode] button to select between
the Wind Chill Temperature Alarm Setting
a n d Te m p e r a t u r e C a l i b r a t i o n D i s p l a y
following the adjacent diagram. Check the
'Calibrating the Temperature' section below
8 C
for more detail on temperature calibration.
!
When the temperature digits are flashing,
0.0
press the [reset] button to scroll through to
8.3
select target wind chill temperature level
(hold down the button to scroll the setting at
a faster pace), or press the [set] button to
select the between wind chill temperature
hold
alarm ON and OFF.
[reset]
!
When the above settings finished, press and
hold the [mode] button for about 2 seconds
to exit the setting sequence.