Craftsman 919.716100 Owner's Manual page 8

PROBLEM
Thin, sandy coarse finish
drying before it flows out.
Thick dimpled finish "orange
peel." Too much material
coarsely atomized.
TROUBLESHOOTING GUIDE
CAUSE
Gun too far from surface.
Too much air pressure.
Improper thinner.
Gun too close to surface.
Air pressure too low.
Improper thinner.
Material not thoroughly mixed.
Surface rough, oily, dirty.
8-ENG
CORRECTION
Move gun closer to surface. See "Hints for Good
Spraying Results".
Reduce pressure.
Follow paint manufacturer's instructions.
Move gun away from the surface. See "Hints for
Good Spraying Results".
Increase air pressure or reduce fluid pressure.
Follow paint manufacturer's instructions.
Mix thoroughly.
Properly clean and prepare surface.