Rear Panel - Pioneer DV-535K Operating Instructions Manual

Rear Panel

DV-535
DV-535K
(*The TV SYSTEM switch is not present
on the DV-535K on the Taiwan model.)
1
COMPONENT VIDEO OUT jacks
If your TV or monitor has component video inputs,
you can produce a higher quality picture on your TV
or monitor by connecting to the component video
outputs on this unit. When using these jacks, be
sure to set VIDEO OUT SELECT to the right position
(page 15).
2
DIGITAL OUT jack (coaxial)
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial output jack to an AV amplifier or receiver
(page 14).
3
VIDEO OUT SELECT switch
Use to set which output is used to output the video
signals. Select either video/S-video or component
video signal output depending on the connections
you make (page 15).
4
DIGITAL OUT jack (optical (OPT.))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
optical output jack to an AV amplifier or receiver
(page 14).
5
CONTROL IN jack
Use to connect this player to another component
bearing the Pioneer Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connect to (page 15).
10
1
2 3 4 5
DIGITAL OUT
COMPONENT VIDEO OUT
DIGITAL
Y P B P R
OUT
OPT
TV SYSTEM
VIDEO
OUT
PAL
SELECT
NTSC AUTO
R L
S-VIDEO
VIDEO
AUDIO OUT OUT
OUT
8 7
0 9
1
2 3 4 5
COMPONENT VIDEO OUT DIGITAL OUT
DIGITAL
Y P B P R
OUT
OPT
TV SYSTEM
VIDEO
OUT
PAL
SELECT
ATTENUATOR
NTSC AUTO
ON OFF
L
R
S-VIDEO
VIDEO
AUDIO OUT OUT
OUT
*
7
- 0 9 8
6
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(page 13).
7
S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-Video jack.
When using this output, be sure to set VIDEO OUT
SELECT to the left position (page 15).
8
VIDEO OUT jack
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability.
When using this output, be sure to set VIDEO OUT
SELECT to the left position (pages 13, 15).
9
AUDIO OUT jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 13,
14).
0
TV SYSTEM switch* (except for DV-535K
Taiwan model)
Use to change the TV signal mode to either PAL or
NTSC according to the type of TV and disc to be
used. When the switch is in the AUTO position, the
player outputs the format on the disc as is (page 16).
-
ATTENUATOR switch (DV-535K only)
Usually set to the OFF position. When enjoying
karaoke, switch to the ON position if the sound is
distorted.
6
AC IN
CONTROL
IN
6
AC IN
CONTROL
IN