Table of Contents
Advertisement
Lights
6.
Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
Pivot the hold-down wire back in
place, and clip the end into the slot.
7.
Install the rubber weather seal
over the back of the headlight
assembly. Make sure it is right
side up; it is marked with an arrow.
8.
Push the electrical connector onto
the socket. Make sure it is
connected securely.
9.
Turn on the headlights to test the
new bulb.
10.
On the driver's side, reinstall the
air intake cover. Reinstall the
three fasteners and secure them
by pushing on the heads until they
lock.
300
Replacing the Turn Signal Light
Bulb
BULB
SOCKET
1.
Open the hood.
2.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
3.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
4.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5.
Turn on the lights to test the new
bulb.
Advertisement
Chapters
Table of Contents
