Honda 2007 TSX Owner's Manual page 193

Operating the CD Changer
Your audio system has an in-dash
CD changer that holds up to six CDs,
providing several hours of
continuous entertainment. You
operate this CD changer with the
same controls used for the radio.
To load CDs or operate the CD
changer, the ignition switch must be
in the ACCESSORY (I) or ON (II)
position.
Do not use CDs with adhesive labels.
The label can curl up and cause the CD
to jam in the unit.
For best results when using CD-R or
CD-RW discs, use only high quality
discs labeled for audio use. When
recording a CD-R or CD-RW, the
recording must be closed in order
for the disc to be played by the CD
player.
Loading CDs in the Changer
To load multiple discs in one
operation:
1. Press the LOAD button until you
hear a beep and see ''LOAD'' on
the display.
To load only one CD, press and
release the LOAD button.
2. The disc number for an empty
position is highlighted and the red
light starts blinking.
3. Insert the disc into the CD slot
when the green CD load indicator
comes on. Insert it only about
halfway; the drive will pull it in the
rest of the way. You will see
''BUSY'' on the display as the CD
load indicator turns red and blinks
as the CD is loaded.
Playing Discs
You cannot load and play 3-inch
(8-cm) discs in this system.
4. When the CD load indicator turns
green and ''LOAD'' appears on the
display again, insert the next CD
in the slot.
Do not try to insert a disc until
''LOAD'' appears. You could
damage the audio unit.
5. Repeat steps 1 through 3 until all
six positions are loaded. If you are
not loading all six positions, the
system begins playing the last CD
loaded.
CONTINUED
187