Table of Contents
Advertisement
ASSEMBLY (continued)
G
Position S-Rod upright.
1
G
Rotate the LOCKING COLLAR fully in the
2
counterclockwise direction.
G
Insert your finger inside the tube and make
3
sure the INTERNAL CAM LOCK is flush with
the inside of the tube.
S-ROD
S-ROD
G
5
G
Insert the MIDDLE STEM into the S-ROD,
4
with the SILVER BUTTON pointed upward
G
Rotate the MIDDLE STEM until the SILVER BUTTON
5
locates in the hole.
G
Twist the LOCKING COLLAR fully in the clockwise
6
direction until it locks.
G
Repeat this process on the LOWER STEM.
7
G
Using the BOLT and KNURLED KNOB, attach the
8
SEARCHCOIL to the LOWER STEM.
G
Adjust the LOWER STEM to a length that lets you maintain a
9
comfortable upright posture, with your arm relaxed at your side,
and the SEARCHCOIL parallel to the ground in front of you.
G
Wind the CABLE securely around the STEMS.
1 0
G
Connect CABLE PLUG to housing.
11
Do not twist the Cable or Plug. Turn Locking Ring only.
Use minimal finger pressure to start the threads. Do not
cross-thread. When the Locking Ring is fully engaged
over the threaded connector, give it a firm turn to make
sure that it is very tight. When the Locking Ring is fully
engaged over the threaded connector, it may not cover
all of the threads.
G
Tighten both LOCKING COLLARS.
1 2
*
Note: Very tall users can purchase the optional Extended Lower Stem (TUBE5X), for extended reach.
Caution:
Forcing in MIDDLE STEM with CAM LOCK raised may form a
burr on camlock. If this happens, remove burr with knife to allow insertion.
LOCKING
G
2
COLLAR
INTERNAL
G
3
CAM LOCK
SILVER BUTTON
G
MIDDLE
4
STEM
MIDDLE STEM
G
4
5
Advertisement
Table of Contents
